Jump to content
SAU Community

Recommended Posts

last night

21, feb i rear ended a charade, my skyline looks ok considering the ground was like ice and i locked up after she decided (within 1 milisecond) that she wasnt going to go through an orange.

anyone know where i can grab a aftermarket 2nd hand or new gtr front bar for a r32 gts-t.

much appreciated :D

thoughts go out to those who have been in similar circumstances or worse

Link to comment
https://www.sau.com.au/forums/topic/10890-minute-silence/
Share on other sites

Well, I caused a 5 car crash on Aus day. Whoops. Just got the car back yesterday....hat off to MB Prestige insurance, absolutely perfect service from them.

The neg driving charge was a downer though :D

Link to comment
https://www.sau.com.au/forums/topic/10890-minute-silence/#findComment-178418
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was that with the cas upside or correct way up?
    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
×
×
  • Create New...