Jump to content
SAU Community

Recommended Posts

I need to completely flush my ATTESSA system and it has been recommended that I use this fluid.

Where can I get Castrol Transmax Z ATF in Melbourne - seems the usual places don't have it. ;)

Regards

Andrew

Edited by BBGTR
Link to comment
https://www.sau.com.au/forums/topic/112882-castrol-transmax-z-atf/
Share on other sites

I need to completely flush my ATTESSA system and it has been recommended that I use this fluid.

Where can I get Castrol Transmax Z ATF in Melbourne - seems the usual places don't have it. :P

Regards

Andrew

Castrol Transmax Z is just a normal synthetic Dexron III ATF, if budget is no issue, Redline synthetic high temp would be a very good bet, meets dexron III, Mercon V & GL-4 spec. The best money can buy.

Redline Synthetic High Temp

Edited by Trex101
Castrol Transmax Z is just a normal synthetic Dexron III ATF, if budget is no issue, Redline synthetic high temp would be a very good bet, meets dexron III, Mercon V & GL-4 spec. The best money can buy.

Redline Synthetic High Temp

Thanks dude, I'll go down to Oil World in Moorabbin here in Melbourne and get some - I get my Redline Gearbox oil from there.

Regards

Andrew

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...