Jump to content
SAU Community

Recommended Posts

Ok guys just want to know how to change my fuel pump as I dont know how to dismantall bits and pieces surrounding to get to it . As I have pulled back seats out with no success and also taken off back shelf in boot with no success and undercar looks like best bet but dont know how.

Could someone pls help as I'm in need........

Thx In Advance

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/
Share on other sites

dont kno about r34s but on r32s the fuel pump is located in the boot, u just take off the plate an a few other screws and i comes out.

Nah the 34 is different I think as there is some sort of round thing in boot but cant seem to c fuel pump.

Pls Guys some help as car is ready to be tuned........ :O:)

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2153044
Share on other sites

Yes you go through the boot.

It's on that shelf part on the drivers side.

There is a metal plate with 4 10mm bolts. Take that off then you will see the top of the tank.

Use a piece of wood and a hammer to get the round plastic cap thing off after you remove the hoses.

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2153401
Share on other sites

Yes you go through the boot.

It's on that shelf part on the drivers side.

There is a metal plate with 4 10mm bolts. Take that off then you will see the top of the tank.

Use a piece of wood and a hammer to get the round plastic cap thing off after you remove the hoses.

I did that but dont know how to get the actual fuel pump out??????????

Is there a procedure for getting it out?

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2153877
Share on other sites

The stock fuel pump is mounted on a "gold" bracket... it is set at an angle into the fuel tank (about 45 degrees). Take your shirt off and reach down into the fuel tank you will be able to reach the pump easy.

From memory, the bracket just slides off it's holding plate with a firm tug - there are no bolts holding it in.

NOTE: Make sure you don't have any sparks or lights shining down there... don't want a fire starting now do ya?

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2154046
Share on other sites

Which pump are you putting in... I hope you have a direct replacement otherwise you're in for a little surprise :ermm:

SHit Dont tell me that I have already have enough surprises!!!!!!!!

I am putting in a Bosch 040!

Does it slide up or something?

Pls tell that this will be ok :ermm::)

Edited by wrxxy
Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2154132
Share on other sites

Thanks for that Bob...

Yes as my sidekick has mentioned it slides straight up...

The Bosch 040 sucks from the bottom of the pump, the stock pump utilizes a "sock" which reaches all the way to the bottom of the tank.

Now here's the choice you have to make;

1) Somehow fix the 040 to the bracket (I had to modify mine) and make a custom extension to the bottom of the tank - you will need a reducer made up and some thick silicon hose that goes to the bottom.

2) Extend the fuel hose and just drop the pump into the bottom of the tank. You may get some "noise" :ermm: But with a little bit of thought, you can get around this.

I went for Option 1) as it seemed like the better one to follow (at a cost of course).

If I was to do it again, I would get the Nismo or Tomei drop in's or use the stock pump and run it into an external pump + surge tank setup.

Cheers

S

Link to comment
https://www.sau.com.au/forums/topic/117099-r34-fuel-tank/#findComment-2154182
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
×
×
  • Create New...