Jump to content
SAU Community

Recommended Posts

Problem Lies in tha ti had to replace my vee port BOV with a plumb back system for defect reasons cough cough. Now the thing is that since i did this hooked up the plumb back system correctly, started up and rough as guts idle very low almost sounds like one of those very sick sounding datsuns that some idiot put cams in, very very bad idle hunting and cant seem to work out wtf is going on,

Tried adjusting it both ways to no avail or resolution, as being one of them turbosmart type 3 plumb back bov's, all lines are hooked up and everything,

If someone might have an answer that would be great, Also smells like it is running slightly rich aswell??

I was thinking air leak somewhere but not sure?

Or please dont tell me (well do) that i need a retune of the PFC to overcome this annoying problem,

Cheers and thanks

Adam

i think you would have , but have you reconnected it to plum back into the turbo intake as that will make it

run like a datto

cheers

Would have which? to do retune or air leak, if someone aswell have experienced this that would be good and yeah its plumbed back into the turbo intake after the AFM, bit confused?

Cheers adam

Hoping for a reply asap as need car running back to normal by well asap

Cheers

Dont worry have isolated the problem, lesson learned never try to do repairs in the dark that is forsure, stupid vacuum hose to the (i think) surge tank or that black tank next to the filter with 3 top hoses

Cheers guys anyways

Adam

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...