Jump to content
SAU Community

Recommended Posts

Hey guys after some input. About 12 months ago i had my RB26 cylinder head fully reco'd in melbourne. About 250km after this i had an accident and totally stripped the car in everyway for a ground up build. When i stripped down the engine (mannifolds) i noticed there was a minor weap on the last (at the back of the engine) exhaust valve stem. Its only the last stem that shows this. The engine has been sitting for quite some time without having been run. For the people in the know: should i remove the head and send it back down to melbourne to the guys that reco'd it? I paid good money and dont see why it would be weaping so soon after the reco. Some guys said it will weap if the 2 valves are open for along time. Thats all fine to say but its only the one seal that appears to be leaking not the pair... Take a look at the pic and let me know what you think

many thanks,

deren

post-14108-1157531408.jpg

Link to comment
https://www.sau.com.au/forums/topic/133227-weapy-stem-seal-need-advice-please/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...