Jump to content
SAU Community

Fs: Cefiro Bits/s13/c33/180 + Dish And Aftermarket Bits

Hella Flush
 Share

Recommended Posts

Hella Flush Experienced

Hella Flush

Posted
Posted (edited)

full 4 stud hubs brakes and stub axle setup front and rear

safety21/cusco 6 point full cage - good for street as it follows all roof and pillar lines

navy blue a31 unregistered/uncomplied 88' cefiro... factory 5 spd manual turbo... fresh 8X,XXXkm engine dropped in - gtr 33 cooler, gtr fuel pump, nismo clutch, eastbear cooler piping etc... many mods can come with it - pm for enquiry/package - has import approval so can be complied easily

fiberglass front and rear fender flares universal - arch type... with rubber seals and stainless hex bolts

random other ceffy shit... series 1 tailights with cefiro written in the middle

kei office front and rear coilovers - height and preload adjustable with front camber tops - need rear tops...

Edited by Hella Flush
NV N01 Experienced

NV N01

Posted
Posted
willing to ship thats no problems aslong as you pay for freight

It might cost a bit to send a whole car up with a cage and coilovers?

Hella Flush Experienced

Hella Flush

Posted
  • Author
Posted

photos can be found here of cage

http://i66.photobucket.com/albums/h252/1at...-10-06_12-1.jpg

http://i66.photobucket.com/albums/h252/1at...22-10-06_12.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
    • DraftySquash
      Looking for someone with a R34 front bar

      By DraftySquash · Posted

      Final update!!! Got the front bar fitted and sprayed and all sorted now. My cutouts worked great and the indicators aren’t just falling off. 😂  
    • Dose Pipe Sutututu
      new 1.5 LSD issues/concerns

      By Dose Pipe Sutututu · Posted

      Is this a brand new LSD? if so, have you followed any break/bed in procedure for it? Usually involves heaps of figure 8 patterns, a fluid flush.
    • MBS206
      Most women will agree that parking is the most taxing part of driving

      By MBS206 · Posted

      It's TWO steering wheels actually. 😛 one for each hand They are wheels, and they steer!
    • PranK
      Most women will agree that parking is the most taxing part of driving

      By PranK · Posted

      Did you even watch the video? Its not a steering wheel. 
×
×
  • Create New...