Jump to content
SAU Community

Recommended Posts

Hey!

I was just making sure I have understood this correctly.

109 Turn signals

A turn signal must — 104

(a) consist of a steady or flashing illuminated yellow sign at least 15cm long and 25mm wide that—

(i) when in operation—is kept horizontal; and

(ii) when not in operation—is kept in a position so it is unlikely that the driver of another vehicle or anyone else would regard it as a signal; and

(b) be fitted to the side of the vehicle at least 50cm and not over 2.1m above ground level, in a position so at the driver of the vehicle, from the normal driving position, can see whether the signal is in operation; and

© be able to be operated by the driver from the normal driving position; and (d) when in operation, be visible from both the front and rear of the vehicle at a distance of 30m.

So, in between the red arrows in the picture I have posted above, the gap can be no longer then 50CM right?

Sorry about the questions guys, just want to make sure before I have to take it to the PITS. :mellow:

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/
Share on other sites

"(b) be fitted to the side of the vehicle at least 50cm and not over 2.1m above ground level, in a position so at the driver of the vehicle, from the normal driving position, can see whether the signal is in operation; and"

By "the side of the vehicle", i would assume that it's referring to the one i circled in yellow instead; at least 50cm from the ground level, and less than 2.1m from the ground level. (i.e. measured vertically, as seen by yellow arrow).

The one with the red arrow is applicable only to clause "d", because it's fitted to the front of the vehicle, and not the side?

imgp3668he2.th.jpg

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703903
Share on other sites

I would say it's:

"(d) when in operation, be visible from both the front and rear of the vehicle at a distance of 30m."

Try standing in front of the vehicle 30m away and see if you can spot your indicator when it's on.

Go to bed already! Weekends are meant for catching up on sleep! :mellow:

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703911
Share on other sites

It's not hard to see from 30m away. I shouldn't have to change anything to it then, via law.

The police that defected me, said they were too close together and too small.

I know they can be seen from 30m away. Hopefully I don't have to change anything on them.

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703914
Share on other sites

Go to bed already! Weekends are meant for catching up on sleep! :mellow:

lol

I so wanted to sleep, relax and maybe have a couple of drinks ..but dammm! I've just been working on the car all morning I am stuffed ..but yeah just want to sort of this one indicator defect cause all the rest have been fixed now.

Grr ..don't you just hate cops sometimes? Esp, when they swear and you when your being nice.

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703917
Share on other sites

They probably defected you on clause "a":

"(a) consist of a steady or flashing illuminated yellow sign at least 15cm long and 25mm wide that—"

Your front ones are really small! Probably time to take out a ruler and start measuring.

*damn* i don't know if mine is even 15cm long! Who has 15cm long indicators anyway??

Or is it 15mm and a typo?

Ah... cops. I hate the coppers here. It's amazing how many idiots form the rank and file in the armed forces anywhere in the world.

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703918
Share on other sites

They probably defected you on clause "a":

"(a) consist of a steady or flashing illuminated yellow sign at least 15cm long and 25mm wide that—"

Your front ones are really small! Probably time to take out a ruler and start measuring.

*damn* i don't know if mine is even 15cm long! Who has 15cm long indicators anyway??

Or is it 15mm and a typo?

Ah... cops. I hate the coppers here. It's amazing how many idiots form the rank and file in the armed forces anywhere in the world.

Yeah, they just told me they were too close together, he did mumble something under his breath about them being too small though.

15CM Long? :mellow: Must be a typo!

I'm in Brisbane too (If that's where you are).

Thanks heaps for your help James :O

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703922
Share on other sites

I just went and looked at my indicators ..they may just pass for size.

When they measure it, it would be from the edge of the indacators?

Yea.. i would think so..? 15mm long and 25mm wide seems like from the side and not from the center.

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703928
Share on other sites

Yeah, I think you are 100% correct.

"(a) consist of a steady or flashing illuminated yellow sign at least 15cm long and 25mm wide that-"

Just says how long and wide they can be, so I think you are right there too.

Ahh well, I should be right when I take it to the PITS then :mellow:

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2703930
Share on other sites

haha my front indicator is a vt side blinker fitted to the very bottom of my front bar. Its about as far off the ground as min ride height haha. Aw well its not like they cops would have trouble finding defects even if the indicators were legal.

Link to comment
https://www.sau.com.au/forums/topic/144790-mod-law/#findComment-2707793
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Im not entirely sure exactly what or where its leaking from, he started to pull the boots to swap to my new tie rods + ends and it just vomited fluid, so he closed em up up, swapped the rod ends to the old rods and let me know so I can figure a solution out, im guessing its all origional as as I passed 103k miles earlier this year im sure its just in need of a full overhual/rebuild anyways.    If i could just yank it off and be good it wouldn't be an issue to ship it out and wait for the turnaround but the guy I work with doesnt really have space to keep my car for a week or two at a time, would rather drop it off and have a replacement ready to drop in
    • What do you mean by "seals"? Internal hydraulic seals (ie, is it leaking PS fluid?) or the rack boots that close the rack onto the tie-rods? Because the former is a rebuild, and the latter is trivial that you or any nearby mechanic could do. Dunno about the cowl. Just buy what you think is required and get anything else you find/break afterwards. Wing? Dunno. Don't like R33s enough to pay attention to them. Mirror glass is just glass (on the surface that you want to polish). Go for it.
    • Hello! Long time lurker, been using the forums to address concerns and questions from afar for a while but I've struggled to find some answers so I guess its about time I made an account and formally asked some more knowledgeable people, since finding local skyline owners is hard (and shops that are knowledgeable or trustworthy to work on 'rare' cars are non existent out where im at, as skylines are quite uncommon to find in the wild around here). So the main 3 questions I have, 1: Steering rack has blown seals, well.. they kind of hold but they are not sealed properly anymore and as my R33 is my DD, i cant exactly rip the rack out and send it off or attempt to fix myself. As most refurb ones are around $1,100 or more shipped, and I have other things I need to work on around the car, I was seeking clarification on whether an S15 rack will more or less bolt right in, and whether a common mechanic could do any other required work to get it to fit. I ask, as I've found a supplier than can sell a manufactured as oem one for around 400, if not I'll likely order a used one from Jacks JDM, and take a risk on the seals there. The second question i have is that im replacing the front wiper cowl and have planned to buy 4 new clips and a new center clip but wasnt sure if there were any other clips that would also need to get replaced while I was at it. Given im sure any that are there now will simply break when I remove the old cowl... Last thing would be a fairly straight forward question, i think. If I manage (strong if, finding one has proven to be a pain) to find a R33 GTR spoiler/wing will it require much modification to bolt to a S2 R33 GTST? I've read the bolt patterns dont match but otherwise would bolt in, only options I have found with much luck is China stuff on ebay and carbonetics, which has a nice $650 shipping fee... so if anyone has any pointers where a US chap could locate one that would be great Random side question as well, the mirrors as I understand are mirror glass, and as im planning to polish my windows from water spots and surface scratches, i was hopeful cerium oxide would be fine for them too, as my research points to, but clarification is always nice. Any pointers would be appreciated, and while I have scoured the internet for answers if I missed a prior post somewhere that may answer these directly please point me towards it, as i must have simply missed it. I have seen a post here or there that has mentioned it, but I usually get 50-50 answers, or half answers... I dont have a lot of fab experience or mechanic experience, outside of hydraulic and pneumatic stuff I did in the military and with how hard it is to source stuff in the US, id rather not wing it and hemmoraghe money lol. Thanks guys! Sorry for the monumental first post haha
    • Yep, there's a very minor drift left that happens a few seconds after letting go of the steering wheel, but not enough to bother me. Enjoying the car still!
    • Got you mate. Check your email!
×
×
  • Create New...