Jump to content
SAU Community

Recommended Posts

Hello everyone!

The time has come for me to sell my Impreza in preparation to buy my dream car... a Skyline!

Subaru Impreza GX MY04 2.0L Manual Sedan

This car is in excellent condition, inside and out and has always been very well looked after, serviced on time with Subaru Glen Waverley and always garaged since new. The car drives and handles brilliantly. Low kilometers, full service history and all receipts available.

Features/Extras:

  • Alloy wheels
  • Rear boot spoiler
  • Headlight protectors
  • Bonnet protector (not fitted, but included in sale)
  • Genuine Subaru carpet mat set
  • Foglamp protectors
  • AMR seat covers used since new

Modifications:

  • Whiteline handling kit
    • Front swaybar
    • Rear swaybar
    • Front strut top bar
    • Rear strut top bar
    • Anti-Lift Kit

    [*]Window tint by Premier Tint Dandenong

There are a few stone chips on the front bumper and a few scuffs on the passenger side; common on almost any car...

Please note that the aftermarket JVC head unit is not included and the original factory CD/radio unit will be reinstalled for you.

Registration until 02/07/07

Remainder of unlimited kilometer manufacturer warranty until July 2009

Kilometers: 46,xxx

Price: $19,500

Location: Rowville, Victoria

Contact: PM, email, or mobile 0408 349 842

Any inquiries welcome. All reasonable offers considered.

Dillon.

post-36410-1177499459.jpg

post-36410-1177499516.jpg

post-36410-1177499547.jpg

post-36410-1177499568.jpg

post-36410-1177499586.jpg

post-36410-1177499606.jpg

post-36410-1177499618.jpg

post-36410-1177499646.jpg

post-36410-1177499659.jpg

post-36410-1177499676.jpg

post-36410-1177499707.jpg

post-36410-1177499727.jpg

Edited by dilmah

Looks like a top quality example dude, good luck with the sale. If your not getting to many bites here id suggest you put it on carsales, if you haven't already.

By the way, how much did the whiteline set-up cost you? I guess the handling got a whole lot better?

Thanks Matt,

The Whiteline kit cost me about $1000 plus about $150 to get some of it fitted as I don't have the tools to it all at home. Anyway, before I fitted the kit, the car was prone to very bad understeer and a lot of body roll. After I fitted everything, the car was transformed! Much less body roll and is much more neutral around corners. It seems to grip the road like never before.

The rear swaybar makes the biggest difference (stock GX only come with front sway bar - nothing else). The front strut top bar allows much better initial bite in the early stages of a corner, but without the rest of the kit, will only exaggerate the understeering.

All in all, if/when I ever buy another Subaru, whether it be a WRX or STi or whatever, I reckon I'd do it all again in a heartbeat!

I don't drive recklessly or speed or anything like that, but I like to enjoy myself a little on the twisties. Good healthy legal fun -- the best kind :mellow:

In case you're really interested, theres some articles on AutoSpeed which is what convinced me to buy this kit: Part 1, Part 2, Part 3, Part 4 and Part 5.

Anyway (didn't mean for this to go on so long :rofl:) I've also listed the car on carsales.

  • 4 weeks later...

Guys & gals, this car is still up for sale.

Price drop to $18,500.

4 brand new Michelin tyres (Energy series), worth $800

Current milage is almost 49,000km

Any and all inspections and inquiries welcome. PM or email me if you want pictures as it looks like they're broken above, or see my carsales ad.

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...