Jump to content
SAU Community

Recommended Posts

For interested people not wanting the tyres

I will sell jst the wheels, includng wheel nuts, lock key and centre caps for $2800

Also im not looking to trade the wheels.

cheers

Edited by SKYLINE05
Link to comment
https://www.sau.com.au/forums/topic/168103-sold/#findComment-3140061
Share on other sites

Im also keen on an answer for this..

For the fronts im pretty sure you'll be safe... Maybe rubbing full lock .. However the rear it will protrude 3.4cm from stock thats a fair bit of space so im assuming it will rub the guards and they will have to be lipped :/

http://www.1010tires.com/WheelOffsetCalculator.asp

Link to comment
https://www.sau.com.au/forums/topic/168103-sold/#findComment-3141049
Share on other sites

Hey guys, not 100% sure about fitting on r34 gtt

they fitted nicely to my s14. Im running stretched tyres on both front and back, to give maximum gaurd clearance, while at the same time, running safe tyre sizes

Best to come down and test fit if ur really keen =)

cheers

Link to comment
https://www.sau.com.au/forums/topic/168103-sold/#findComment-3141177
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...