Jump to content
SAU Community

Recommended Posts

My R33 struggles to start from cold. In the morning I'll start it and will need to really pump the accelerator before it will take. Every other start after that will be fine, but the next morning it struggles again. I always leave it on ignition only for a few seconds for the whole thing to get ready before I actually start.

From reading just about half the posts on SAU I have found that this is a fairly common problem and there are many possible causes :worship:

I think I have narrowed it down though and need some other opinions

I have a volt meter in my car and when starting it will drop to about 8 volts... from what I understand... this is way too low

If I understand correctly, this is caused by the starter motor arcing due to worn brushes

I was thinking of getting a starter motor from a wreck and swapping them over to test the result

Does this seem like the logical next step? Does anyone have any other opinions on the problem?

My car is a '93 R33 Series I GTS

In summer when the temperature is higher, the car starts fine, but the voltage still goes to around 8 volts.

Thanks... really want this sorted :)

Link to comment
https://www.sau.com.au/forums/topic/172314-engine-struggles-to-start-when-cold/
Share on other sites

Check your sparkplugs, running high-octaine fuel? got your car serviced recently?

8 volts is a bit low, on standard I think my car stays on like 12 volts or something. Also, have you checked your battery - enough charge in there - here's an inexpensive thing you could try - bring it to a mechanic, as him to fully charge up your battery for you - would cost around $20.00 or something, then see how you go. I've noticed with my car if I don't drive it enough, sometimes it will die down a bit.

Good luck.

My battery is brand new... found the most powerful one that would fit in the space

I tried putting in new spark plugs, but no change and I always use BP Ultimate 98RON

Didn't know about the oil though... I replaced the oil a few months back, can't remember the viscosity, but it was recomended to me by the mechanic for my car and its k's, so should be ok

Any other ideas? When I start it after its already been started once in the day, the voltage doesn't drop as far. It drops to about 10 volts. Its only the first start on a cold morning that it drops really low and struggles.

Thanks for the input so far guys :thumbsup:

I'm not too sure mate, I think it depends on how worn out your engine I think. The more worn/old it is, the thicker the oil should be. I don't know much about oils honestly.

Hopefully someone who does know will come and give their recommendations.

well boys i have had this same issue over the past 6 months, and it's a common thing, but belive me there is no sollution that i found.

I had replaced everything in the car, electrical that is, all new sensors, and test and so forht, you name it we tried it, eaven a new set of injectors, no good, then one day it came good, no idea how or why, but has been fine everysince. So bugga.

It's a pain in the ass to find too, seing as you only get one chance a day to diagnose it.

Personaly, i would start by cleaning your AFM. Also test or buy a new Engine temperature sensor, as this oftern plays havoc with the car. also put a new fuel fulter in the car and get the injecotrs cleaned, it may be that one is leaking a bit.

After that it's all trial and error.

I had new AAC valve, CAS, AFM, TP, ECu temp sensor, ECU, COILS, ect ect.

Thanks WogsRus... In my many hours of searching the forum I read heaps of things you had written... I will be trying all these things and hopefully don't struggle as much as you did :)

It may take a while to test each thing, because, as you said, you can only test what you tried once a day... I'll keep this post updated each weekend I try and make progress for all the others with the same problem... hopefully we get it sorted out ;)

If anyone else has any more insight, please let me know

Cheers

hey adam

i have the same car and the same problem..with mine it clicks over first time but the rev's are very low like its going to die but after a second the rev;s jump up the correct idle...

interested to find out

Any chance you've got a fmic installed? I noticed that I had to blimp my throttle everytime I start the car in the mornings for it to get going after I installed my fmic. Not sure why it happened after the installation of the cooler, but I've had to. A little blimp of the throttle to get the car going isn't a big deal.

when you crank a car it's getting pretty close to a short circuit across the battery (you pull a LOT of amps) so the voltage will definitely drop - 10V would be a GOOD figure. 8V is probably normal.

maybe the cold start sensor is buggered or something? I assume there's a coolant temp sensor that's different to the one that runs your gauge....

i had the same probly on my r32 i cleaned acc valve ect but havent cleaned the one under the plenium yet... but ive found it struggles on cold mornings like you but lately ive been putting the siliencer in my exhaust in the morning when i start it and let it warm up bcoz my cars very loud.... and its always starts first time no worries with the siliencer in its quite funny... :D good luck who knows what the real problem is behind it but everyones car seems to do it.

I started my car the other day (r33) and as Idont drive it often it struggles in cold also.

It actually seemed like my coils as it sounded a bit like a rexy, did that for about 3 seconds and then ever again.

Must admit also there was a different smell coming out of the exhaust - bit like a kero smell rather than fuel!

weird.

I try and start it now once a day

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sounds like you've got an interesting adventure ahead here with local support if you have trouble! My guess is that, unboosted, you will be OK with a small upgrade like -9. What will happen is that once the stock ECU sees more airflow than it expects it will add a heap of fuel and pull a heap of timing to be safe because it can't understand how it could get that much air without there being an issue. You will see clouds of black smoke and it won't pull hard through the midrange and top end. So, overall it will be a bit frustrating but should be OK. If you are still nervous set the base timing back 2o through the CAS, but it will be even more sluggish everywhere. As said above through...this is not my guarantee your engine won't be blown into a million pieces, leaving you looking for very hard to find parts A better idea is get a computer with logging ASAP, wire in a wide band O2 sensor and a use remote tuner. I've done multiple cars this way and while it is not as good as a specific tune on a dyno they can get it 90% right. I'd suggest if you can afford an R33 GTR these days you can afford an ECU and tune. And if you can't afford that you sure won't be able to afford the rebuild if it goes bad in the meantime,.  
    • Yeah it would be nice if someone took the time to put that sort of information together, but there are a lot of variations in looms. I think you are making this way hard for yourself if you just want to get it running....sourcing an SR20 with the right wiring will be a billion times easier than matching the RB loom to an S15 chassis. If you do end up going this way, you just need to trace every wire in the loom with a multimeter, 95% of them will go to a location you can confirm at the ECU.....and then post it up for the next person who needs it  
    • Just top it up with water, and keep a general idea of how much you added. It is normal for water to be pushed into and pulled out of the reservoir through the cap, and it should not be more than half full or it will be likely to overflow when hot. Any decent mechanic can do a pressure test of the cooling system to confirm if you have a leak. Keep in mind if it is only leaking a little and when hot it may well evaporate before you see it hit the ground
    • I'd ask the shop what they used and use that. Mixing coolants is sometimes OK, sometimes not, and you have know the details of each coolant to know whether it's a good idea or not.
    • Is it alright to top up with just another green coolant?
×
×
  • Create New...