Jump to content
SAU Community

Recommended Posts

just noticed my oil temp is around the half way mark for the past couple of days as per the centre gauge

wed night i noticed the radiator collant was boiling too? i checked the coolant level today and radiator had to be filled a little to top it up but the reserve was ok

checked engine oil level this morning and thats fine

engine temp is sitting half way as per normal

oil temp doesnt really go past 1/2 way

what could be causing this?

cheers

jeff

just noticed my oil temp is around the half way mark for the past couple of days as per the centre gauge

engine temp is sitting half way as per normal

oil temp doesnt really go past 1/2 way

what could be causing this?

Sounds normal to me.

I'm not so sure about that.

My GTR and many of the other ones I test drove before buying my one doesn't get anywhere near half way on the oil temperature gauge under normal driving conditions.

Around town, mine is around 80 degrees or so. Hard to tell where that is exactly, but the gauge is still hovering over the numbers "70"... so basically about 1/6th of the way up the gauge from the bottom.

Driving on the highway at 110, it tends to go up to 90 degrees or so. still below halfway. Apparently (yet to see this), but on track use, it should get around half way up the gauge or perhaps more (??). When was the last time you changed your oil, oil filter and stuff?

What about oil pressure? Should never go below 2 or above 6-7 in my experience...

Also, how did you know your coolant was boiling?

It can depend on many things. How hot it is outside, how hard your driving, if you have an oil cooler etc...

Daily driving i get around 80-90... on hot hot days even 95-100...

Around the track i've had it up to 130..... which is where i start to ease off.....

no oil cooler and the half way mark of oil temp is just from normal driving (no boost) after about 40mins worth of driving...

oil change (motul chrono 10w40) about 1500klms ago.

as for the boiling coolant, you can actually hear it before it starts flowing through the reserve and leaks out eventually!

got it booked it at Advan on monday to try and figure it out.....hoping its thermostat or blocked radiator or something simple.....doing a cylinder leak test so we'll see what that brings up :?

could it be a stuffed cat converter?

would dying turbos cause this?

Edited by jeff

Ive had boiling coolant before in my GTR when i first got it and the cause was a radiator that was block to about 80%, i got a new 2 core radiator and new thermostat and it solved it straight away. My oil temp sits at about 80 and 90 odd when driving for a longer period of time.

  • 1 month later...

2 weeks pass since the visit at Advan

the radiator starts leaking....so I baby the thing to the workshop (not the same workshop as mentioned above, never again!)

turns out the radiator is blocked (apart from the obvious leak that just started)

ended up buying a new radiator from Justjap, change thermostat (old one was OK), changed clutch fan just because and i couldnt get a refund anyways (old one was also in great condition)

Now, my water temp is always below 1/2 way, oil temp just gets above the 70 mark on the gauge even with a bit of spirited driving and aircon on!!!!

Moral of the story, dont think a well known tuner can solve all of your problem! Had a feeling that the radiator was stuffed but decided to listen to the mechanics!

But what can you do, it is a GTR and I'd rather spend a few $ for someone in the know to figure things out rather than spending thousands to fix the engine!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I mean, I can confirm the TPS is at 100%.... I can confirm when we installed the TB and setup the cable that the TB was indeed fully open at max pedal travel.. the same 'curve' (WRT MAP vs MAP) existed with the previous setup/TB/manifold as well... No, we did not do a run with no intake connected. I would love to go back in time to do such a run to rule out the intake. It would have also been good to do a run with the airbox lid off. There's a test there where increased IAT vs more available air could be a positive tradeoff. I remember taking the lid off my R34 Turbo setup back in the day and noticing a monster increase, even if IAT's did go up. Could be similar. Hard to test unless I find a very deserted road. 
    • That's actually encouraging to be honest. my motor was rebuild many years ago but it's probably done less than 30,000kms and fucc all limiter or drift, majority street / drag / roll racing. It'll be fine 💪🏼 I don't even have lines or a can for the cam breathers installed yet, there is zero oil residue or splatter on or around them, it drives beautifully so it seems healthy. Just a ticky lifter, yet they're almost brand new oem genuine Nissan and haven't done many kms at all...
    • Have you confirmed the throttle body goes to WOT (and stays there) during the run?
    • I'm having a problem. I think it was mentioned above somewhere but can't see it.  I'm stuck in the cycle of, sand, filler, low spot again, put filler, sand, low spot again, now i put filler again and a thicker portion which seems to have helped but I got low spots in other areas. In the image. Circled in red thats where the original low spot was and the shape is the same as the red out line. I've more or less fixed that (still low spot up the top but now I have low spots where the green circled part is.  Is likely the issue that I didn't start with a course sand paper? I sanded the filler with 240 to reduce the risk of not going to far but maybe the issue is that I'm only taking off enough material to remove some of the filler but not the high spots. I now started sanding with 120 and I think I'm seeing a difference. I did fix one dent the other 2 are f**ked and seems like I made another low spot which is indicated by the furthest green circle on the left handside. Any thoughts and solutions?   Also second image. All of these rock chips, can they be filled in with primer or do i need to fill them all with filler/putty? So many rock chips on mine lol.
    • Well, I had an Edward Lee's special edition odo windback car/motor with a RB25DET S2 and I put down 372kW with a good amount of track abuse for 1.5 years before the ring lands decided it didn't want to stick around anymore 🥲 But probably didn't help I kept on smashing try limiter on the track and a few skid pans.
×
×
  • Create New...