Jump to content
SAU Community

Recommended Posts

Hey all,

just need some help if anyone has some ideas, just picked up the GTR from the mechanic had its regular service, + i changed brakes and rotors.. now everytime i touch the brakes it really makes a loud horrible screeching noise.. mechanic said that is normal for new brakes and rotors..

i am getting headaches everytime i drive my car not to mention the bad stares aswell for the wrong reasons :thumbsup:.

please some advice to get rid of the noise..

cheers

G

Link to comment
https://www.sau.com.au/forums/topic/186126-need-help-brakes/
Share on other sites

hmmm, they might need beding in, or they didnt grease up the slides proply...

brakes are touchy sometimes, at work we gotta even spray the pads (only new ones) in a "no squeak" stuff, and put a small amount of grease on the top n bottom to also stop squeaking. then we have to take the car for a drive and bed them in, get them hot and cool down again...lol. boss is pretty strick on brakes.

where are you located?

sure its not something simple like a rock had flicked up? do you know if its the front of the back that the noise is comming from?

take the wheels off and check the brakes for anything "un-normal"?

OR, take it back to the mechanic and ask them about the noise.

theres a few options for you :thumbsup: hope you find it mate.

cheers

CJ

Edited by -_-StRyDeR-_-

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...