Jump to content
SAU Community

Recommended Posts

Someone on Chapel hit my rear bumper and damaged it.

They left a note: "I'm sorry but I've bumped into your car. Sorry"

Another note said: "Some lady crashed into your car. Look @ back right hand side of your car. Number plate ######. Silver sedan"

I bet she put the note just because people were looking.

What should i do as there are no contact details of the b!tch or the witness???

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/
Share on other sites

Guest RedLineGTR

dam...go down to the cop station *yes i know* either in that are another...give em the rego tell em to get some details...if it's a insurance job then get the insurance to call them...dont know if they hand out details..but maybe they might...give it a try..,.maybe someone on the forum can get some access to her/his details

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-406275
Share on other sites

yeah. just went to the police and they said they will send the boys around to check her car. But basically as there are no contact details, if she denies it then that's that!

I hope she was blonde and not smart enough to wipe off any paint evidence. I will track her down myself... I have her number plate and if i see her, i'm gonna get my 4wd and crush her car!

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-406312
Share on other sites

run the ho down!! or if shes good looking make her pay u back in sexual favours :(

i remember the same thing happend to me with my front bar and some chick left a note to say some wanker in a merc backed into my car... i didnt bother doing anything as i had a new front bar anyway i was going to put on... i should have tho...

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-406780
Share on other sites

yer i know how u feel.

some person hit my car @ about 60 k's

and hit the tree in my front yardas well.

it threw my 3 and 1/2 tone 4x4 five meters.

and yes they did the runner.

luck i had a bull bar.

and it still was about 2 k damage.

all that i had to pay outof my pocket.

and when i rang the cop's they lookes at me like was full of shit.

just because the frond end of the car was damaged.

thats why i think pigz are ghey

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-407049
Share on other sites

Guest terrance
Originally posted by RedLineGTR

The cops should handle it...for once they are put to good use...thoe a baseball bat to the persons car would be good also after she pays up.

i dont understand your logic

the police officers of melb are put to a lot of use. they are over worked and understaffed as it is. not to mention underpayed and underappreciated.

and why would you hit her car after she pays for damages? it doesnt make sense.

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-407418
Share on other sites

i walked into the police station today and asked what is going on as i still haven't received a call... they said to call back later on in the week... when he opened the one way mirror door, i saw inside coppa having coffee and donuts...haha.. funny sh!t.

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-408953
Share on other sites

This happened to me in sydney, a note was left with no contact details, the police said if the guy denied it, there was nothin i could do. They said they would call back, but never did, i didnt bother following up because i knew if the guy was gonna admit it, he would have left a note himself.

I know his rego tho..............

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-409651
Share on other sites

CR34TION - call them up every 3 hours... they will get so sick of you that they will do something.

we had our ATV (4 wheeler motobike) stolen about 1month ago... reported it stolen from our property... they never even bothered coming to property to check it out and never called us etc to let us know that they couldnt find it etc.. fat ****s too busy eating donuts and handing out defects.

Link to comment
https://www.sau.com.au/forums/topic/19354-hit-and-run/#findComment-410293
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update 3: Hi all It's been a while. Quite a lot of things happened in the meantime, among other things the car is (almost) back together and ready to be started again. Things that I fixed or changed: Full turbo removal, fitting back the OEM turbo oil hardlines. Had to do quite a bit of research and parts shopping to get every last piece that I need and make it work with the GT2860 turbos, but it does work and is not hard to do. Proves that the previous owner(s) just did not want to. While I was there I set the preload for the wastegates to 0,9bar to hopefully make it easier for the tuner to hit the 370hp I need for the legal inspections that will follow later on. Boost can always go up if necessary. Fitted a AN10 line from the catch can to the intake hose to make the catchcan and hopefully the cam covers a slight vacuum to have less restrictive oil returns from the head and not have mud build up as harshly in the lines and catch can. Removed the entire front interior just shy of the dashboard itself to clean up some of the absolutely horrendous wiring, (hopefully) fix the bumpy tacho and put in LED bulbs while I was there. Also put in bulbs where there was none before, like the airbag one. I also used that chance to remove the LED rpm gauge on the steering column, which was also wired in absolute horror show fashion. Moved the 4in1 Prosport gauge from sitting in front of the OEM oil pressure gauge to the center console vents, I used a 3D printed vent piece to hold that gauge there. The HKB steering wheel boss was likely on incorrectly as I sometimes noticed the indicator reset being uneven for left vs. right. In the meantime also installed an airbag delete resistor, as one should. Installed Cube Speed premium short shifter. Feels pretty nice, hope it'll work great too when I actually get to drive. Also put on a fancy Dragon Ball shift knob, cause why not. My buddy was kind enough to weld the rust hole in the back, it was basically rusted through in the lowermost corner of the passenger side trunk area where the wheel arch, trunk panel and rear quarter all meet. Obviously there is still a lot of crustiness in various areas but as long as it's not rusted out I'll just treat and isolate the corrosion and pretend it's not there. Also had to put down a new ground wire for the rear subframe as the original one was BARELY there. Probably a bit controversial depending on who you ask about this... but I ended up just covering the crack in the side of the engine block, the one above the oil feed, with JB Weld. I used a generous amount and roughed up the whole area with a Dremel before, so I hope this will hold the coolant where it should be for the foreseeable future. Did a cam cover gasket job as the half moons were a bit leaky, and there too one could see the people who worked on this car before me were absolute tools. The same half moons were probably used like 3 times without even cleaning the old RTV off. Dremeled out the inside of the flange where the turbine housing mates onto the exhaust manifolds so the diameter matches, as the OEM exhaust manifolds are even narrower than the turbine housings as we all know. Even if this doesn't do much, I had them out anyways, so can't harm. Ideally one would port-match both the turbo and the manifold to the gasket size but I really didn't feel up to disassembling the turbine housings. Wrapped turbo outlet dumps in heat wrap band. Will do the frontpipe again as well as now the oil leak which promted me to tear apart half the engine in the first place is hopefully fixed. Fitted an ATI super damper to get rid of the worn old harmonic balancer. Surely one of the easiest and most worth to do mods. But torquing that ARP bolt to spec was a bitch without being able to lock the flywheel. Did some minor adjustments in the ECU tables to change some things I didn't like, like the launch control that was ALWAYS active. Treated rusty spots and surface corrosion on places I could get to and on many spots under the car, not pretty or ideal but good enough for now. Removed the N1 rear spats and the carbon surrounding for the tailpipe to put them back on with new adhesive as the old one was lifting in many spots, not pretty. Took out the passenger rear lamp housing... what do you know. Amateur work screwed me again here as they were glued in hard and removing it took a lot of force, so I broke one of the housing bolts off. And when removing the adhesive from the chassis the paint came right off too. Thankfully all the damaged area won't be visible later, but whoever did the very limited bodywork on this car needs to have their limbs chopped off piece by piece.   Quite a list if I do say so myself, but a lot of time was spent just discovering new shit that is wrong with the car and finding a solution or parts to fix it. My last problem that I now have the headache of dealing with is that the exhaust studs on the turbo outlets are M10x1.25 threaded, but the previous owner already put on regular M10 nuts so the threads are... weird. I only found this out the hard way. So now I will just try if I can in any way fit the front pipe regardless, if not I'll have to redo the studs with the turbos installed. Lesson learned for the future: Redo ALL studs you put your hands on, especially if they are old and the previous owners were inept maniacs. Thanks for reading if you did, will update when the engine runs again. Hope nothing breaks or leaks and I can do a test drive.
    • No those pads are DBA too  but they have colors too. I look at the and imo the green "street" are the best.
    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
×
×
  • Create New...