Jump to content
SAU Community

Recommended Posts

RICE DROP 12500 NEEDS EITHER NEW CLUTCH OR CLUTCH FORK

HEAPS OF SPARES EXCELLENT CONDITION CAR JUST CANT AFFORD TO KEEP IT WANT IT GONE

Make: Nissan

Model: Pulsar Gti-R

Milage: 147,000

Transmission: 5spd Manual

Colour: wrc blue

Location: Melbourne

RWC supplied? no

Currently registered? yes

Price: 14,000ono

Contact: Mick on 0431077303

Comments / Modifications:

comes with brand new and uninstalled

-engine hose overhaul kit

-clutch fork

-release bearing

-clutch fork pivot ball

INTERIOR

apexi boost guage, autometer a/f ratio guage, greddy turbo timer, battery relocated to boot, clutch

pedal support bracket, clean standard seats & trim

EXTERIOR

recent respray in WRC Blue with all new rubbers, 17" gmax rims, DBA front & rear slotted rotors,

clear side indicators

ENGINE & DRIVELINE

HYBRID FMIC w/heat wrapped cooler pipes, bosch 984 fuel pump, malpassi rising rate reg w/fuel

pressure guage, 3" full stainless exhaust, Magnaflow muffler, highflow cat, oil catch can, hks pod

filter, turbosmart duel stage boost controler, GFB blow off valve, xtreme lightened alluminium

flywheel, xtreme ceramic 9 puck xtra heavy duty clutch, spark plug cover, whiteline front strut

brace

FOLLOWING PARTS ARE LESS THAN 6000KLMS OLD

clutch fork boot, gearbox thrust bearing, chain tensioner, dizzy cap and rotor button, recon

front driveshafts, clutch slave cylinder, clutch master cylinder, water temp sensor, coolant temp

sensor

XTRAS (SPARES)

used lockwood white face dials, 1x set of arias forged pistons with rings, 2x cylinder heads, 1x

reground cams, 1x standard cams, 2x standard valves pring sets, 2x head bolt sets, 1xrocker

cover, 1x standard bore block, 1x 20thou bored block, 2x sumps, 2x oil pump timing cover

assembly, 2x conrod sets, inlet manifold with plenum, quad throttle bodies, fuel rail with standard

injectors, permaseal full gaskit kit, spare hatch with spoiler and glass, two front bars that need

minor repair, 1x rear bar, standard top mount intercooler, l/h indicator, l/h electric mirror, driver

side door with wind shield, right hand guard, air con condensor, pump and lines, gtir manual on cd,

tail shaft, box of bolts, wiring, bearings and other

stuff.

This car is extremely well maintained and has been serviced every 5000klms with motul oil.i wash

it every w/end and polish it with auto glym polish every 2nd. i always let it warm up before driving.

while i have owned it, best 1/4 mile time 13.121 on 13psi , currently has 172 kw atw on 15.5psi

with dyno sheets to prove, tuned a little rich to be safe so could gain a few extra kw by advancing

timing. good for a high 12 sec pass.

any test or inspection welcome

4months reg comes with the plates LILZLR

doesnt come with rwc but the car should pass easily enough

Images: post-44653-1195369493_thumb.jpg

post-44653-1195369752_thumb.jpg

Edited by LILZLR
  • 1 month later...

RICE DROP 14,000 FIRM NEEDS EITHER NEW CLUTCH OR CLUTCH FORK

HEAPS OF SPARES EXCELLENT CONDITION CAR JUST CANT AFFORD TO KEEP IT WANT IT GONE

CONTACT ME ON 0431077303 MICK

Edited by LILZLR
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
    • It's needed for rolling idle up, and I think it is a decider on VCT also.
    • I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...