Jump to content
SAU Community

Recommended Posts

I AM NOW SELLING MY RB30ET COMPLETE WITH HIGHFLOW AND ALL BOLTONS, EVERYTHING IS NEW, EVERY SINGLE GASKET, WATER PUMP, POWER STEERING PUMP, NEW BOTTOMEND 20THOU OVER AND TOP END, HIGH FLOWED TURBO, WITH NEW HOUSING, COMES WITH BRAND NEW HEAVY DUTY CLUTCH

BLOCK HAS BEEN REPAINTED WHEN IT WAS APART ALSO THE TAPET COVER

asking 2500 ono

CALL ME DAN 0405233458

post-38616-1197502132_thumb.jpg

post-38616-1197502106_thumb.jpg

post-38616-1197502068_thumb.jpg

post-38616-1197502045_thumb.jpg

post-38616-1197501994_thumb.jpg

Edited by ragex

how much for items?

What are the specs of the turbo? I don't think anyone will buy something they nothing about not even a hint on the specs...

And just to confirm your just selling the manifolds, head and turbo, no cross over pipe?

So the information on the rebuilt engine is meaningless, as your not selling it, right?

ALL STANDARD IM NOW SELLING THE MOTOR COMPLETE HAVING TOO MUCH TROUBLE USING THELOW COMPRESSION PISTONS ON MY CONVERSION

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Brakes definitely won't make him faster. They only slow you down. 😛
    • cool car to be working on, but I think you need some really old school help on this one
    • Hey, I understand this is a skyline forum but I was hoping someone might be able to help me out here. Got an ‘84 M10 Prairie with an E15S that I’m trying to get running again after replacing a head gasket. I’m having some struggles with vacuum lines after replacing a couple perished ones. They’re all set up like in the diagram I’ve attached. I’ve tried starting the motor and my carb backfires a bit but no luck getting it to run.      Theres a 2nd port on the back of the carb that isn’t mentioned in the diagrams, right next to what I believe would be the idle screw (sorry I’m no good with carbs) - should this be attached to any lines?   any help would be greatly appreciated, I’m sick of pulling my hair out trying to figure this thing out 🤝🏼
    • If the current relationship is between the diff and the speedo, then no, you will not need a speed sensor in that hole in the gearbox. If the car were an R33 GTST, or an R34 GT-T, then it would need a speed sensor in there. Because that's what those cars have/need. If the car were an R32, then it will need a cable drive cobbled together from a Navara speedo drive, because R32s can't handle an electronic speed signal to the speedo.
    • Just to follow up on this.  Will the speedo work with this? Like to have plugged speed sensor on this trans and still using one on diff from N/A (open) diff?
×
×
  • Create New...