Jump to content
SAU Community

Recommended Posts

  • Replies 163
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Okay lets make it for Friday the 14th. say 7:00pm?

Meet at either Pac Fair Carpark or Convention center?

Lets make this 7:30pm as I dont get home from work until 7 most nights.

This being the case, Pac Fair is only up the road from my place so lets meet here!!!!

7:30PM inside the Pac Fair Carpark next to the mobile/caltex fuel station.

I'm hoping to have my skyline back on the road this weekend.

Just waiting the outcome after it goes into the workshop on Thursday night and get it back Saturday afternoon :)

Lets make this 7:30pm as I dont get home from work until 7 most nights.

This being the case, Pac Fair is only up the road from my place so lets meet here!!!!

7:30PM inside the Pac Fair Carpark next to the mobile/caltex fuel station.

I'm hoping to have my skyline back on the road this weekend.

Just waiting the outcome after it goes into the workshop on Thursday night and get it back Saturday afternoon ;)

There is a caltex on the gc highway or a quix(i think from memory) closer to the bus mall or along hooker blv towards nerang ect. Were talking about the one near hooker blv rite?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...