Jump to content
SAU Community

Recommended Posts

Hey Guys,

I'm trying to surprise a friend with her favourite chocolate, but she wont tell me where to get it from...

They're Peanut Butter Cups, but I dont know the brand name, and they are VERY rare. Brought in from America, and only sold at a few places.

Does anyone know where to get it from?

They look like M&Ms apparently, and have peanut butter in them with chocolate.

HELP ME OUT HERE!!

Rhys

Link to comment
https://www.sau.com.au/forums/topic/222911-peanut-butter-cups/
Share on other sites

dude they're not that rare, i've seen them in IGA and other special candy stores like 'sugarfix'.

Funny how you say its not that hard to find but your not even from WA, how do you know its easy to find over here? We dont even have a sugafix store!!!

Anyway i would try the lollishops in markets as they usually have "world lollies"

Reeces Peanut Butter Cups.

There is a shop in London Court that sells mainly english chocolates but also sell the peanut buttercups.

There is also another shop that sells them in Carrillion Arcade near EB Games and Dirtcheap CD's. This one has a bigger selection.

Grab some peanut butter m&m's while you're there, they're teh b0mb!

Edited by bubba

Theres a lollie shop in mandurah that has heaps of stuff. . im guessing it would be too far away though. .

One of the big kit kat fingers has peanut butter in it too. . and another with cookie dough :D yum haha

yeh i know but still im not a fan of reeces or any american choclate aye,

i worked in the us for 6months last year and my mum frequently sent me cadburys, the yanks loved it

Yeah even my mates' wife reckons our chocolate is better than in the US. English Cadbury's is better again as they don't need the heat preservative that we put in our chocolate here.



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...