Jump to content
SAU Community

Recommended Posts

Make:Mistubishi

Model:94 GSR

Milage:94,000kms

Transmission:5 speed manual

Colour:White

Location:Sydney

Complied?Yes

RWC supplied?Yes

Currently registered?Yes

Price:$27500 ono

Contact:Pm Best

Comments / Modifications:Hey all my brother is wanting to sell his Mitsubishi Lancer GSR. This car has been extremly modified by TRP (Tony Rigoli Performance). This car has absoultely everything done to the engine.

This car is an extremly quick street car. Makes 309kw@all fours on pump fuel. Will run a 10sec pass. It is also fully enginered.

The list of mods is too long so if anyone is interested PM me.

Images:

post-16690-1221397774_thumb.jpg

post-16690-1221397938_thumb.jpg

post-16690-1221397993_thumb.jpg

post-16690-1221398022_thumb.jpg

post-16690-1221398039_thumb.jpg

post-16690-1221398050_thumb.jpg

Edited by GTR32X
Link to comment
https://www.sau.com.au/forums/topic/236066-mitsubishi-lancer-gsr/
Share on other sites

  • 1 month later...
I hope no one is intersted isn't this meant to be a skyline forum.

Yes it is! And also on your profile it says you own a Lancer!!

But this is one serious Lancer that has had over $20,000 spend just on the engine.

Its a 2.4L billet stroker crank and every single engine parts has been upgraded.

If you were to drive this car you would know its a serious car and lacks nothing

You should also try Boostcruising or vr4.org or a evo forum.

thanks for the advice. I did put it on Boostcruising but there are sooooo many cars on that site.

I will try those other forums

thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • About $4k brand new, available from vendors in Oz, or via an importer from Japan. Although that is for an R34 box, so you also need to buy the push clutch front plate (brand new from Nissan) and swap that over, and drill the bellhousing for a push clutch slave cylinder.
    • Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
×
×
  • Create New...