Jump to content
SAU Community

Recommended Posts

FOR SALE:

*R33 GTR V-Spec Factory Suspension (With Nismo Lowed Springs): $400

*R33 GTR V-Spec Factory Fuel Pump: $90

*R33 GTR V-Spec Factory Airbox Snorkel: $50

*HKS GT3037s Twin Turbo Kit (Full Kit, Straight Bolt On to RB26/RB25): $5000 (FREE POSTAGE INTERSTATE)

*Xforce Stainless Muffler (Twin 2" Exit Pipes): $90

Please PM Me About The Items, If you Like Something That I Have Advertised Drop Me a Message!

Edited by F u r i o u s
ITEMS LEFT FOR SALE!

*R33 GTR V-Spec Factory Suspension (With Nismo Lowed Springs): $400

*HKS GT3037s Twin Turbo Kit (Full Kit, Straight Bolt On to RB26/RB25): $5000

I might need the wastegates alone - my kit came with tials that don´t fit :)

Would you sell them?

sorry mate will not just sell the wastegates, i will split the kit if you find another buyer but if not i will only sell as a full kit

I would always wanted to know..............

would that suspension fit on a Gts25t

no sorry the 33R GTR suspension is the same as the 34R ones and nothing else

ITEMS LEFT FOR SALE!

*R33 GTR V-Spec Factory Suspension (With Nismo Lowed Springs): $400

*HKS GT3037s Twin Turbo Kit (Full Kit, Straight Bolt On to RB26/RB25): $5000

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...