Jump to content
SAU Community

Recommended Posts

heyas

Alpine Cassette Receiver(TDM-7546E) incl. CD shuttle control.

:- 35x4 amps

1yr and 3 mnths old

Full working condition in every aspect

Comes with the sorround for the dash

The original padded Alpine box to keep the removeable face.

Came out of my Skyline so should be a straight fit for Skyline.

Alpine CD Shuttle 6 CD Changer (5951Z)

:- Full working condition

Plays burnt cd's great with no problems

All screws avail. for mounting

Enough cable to go from boot to deck with leftover.(Got gyped here, the old installer musta sold me alot of cable and just left the remainder coiled up behind the deck)

sOrrY...typo on the price of e changer.

MB Quart QM130 Competition Series Speakers

:- Powerful 180 max output MB Quart Competition Speakers

Single DIN In Dash Tray with Spring Operated Door

:- The tray that goes under your single DIN deck unit. The tray is

original from Nissan with the car and in excellent condition with

no scratches or colour fade

EVERYTHING FOR $350.

Prefer to seeelll all at one go too!!:)

Preferably in Perth and will sell interstate if no choice.

Selling cause i bought a double DIN set from someone in the forum.

If ya need pics, post here or PM me and post here cause i rarely chk my PM and i dont get any notifications telling me i have PM but if u post here, i get a notification.

Thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...