Jump to content
SAU Community

MeLz CruiZe Cruise - 23rd January 2009


Recommended Posts

  • Replies 140
  • Created
  • Last Reply

Top Posters In This Topic

Acutally if you post this up on a few forums around the place you will get a fair few along who fit the profile.

My Camry is fulleh sik uleh! :domokun:

I know ;) but problem is my friends aren't secluded to jap spec. I have allot of bogan mates on Calais Turbo and such

my car is getting work done on the 19th. might not be able to make this 1. very sorry mel, supose theres always next time.

Hopefully there will be a next one if I do this right :( lol

Oh Hai Reece make sure you come itnroduce yourself cos we've never met before lol u funny kid sif not know who you are haha

Umm ok and this is for Ricca and all other SoR'ers

There is only 2 meetpoints SoR the majority of the cruise is NoR

Edited by MeLSki
  • 2 weeks later...

Kurt (invasion) I can't PM for what ever reason. Just so you know the meet poitn is actually specified in the initial post if you read it it clearly states Dogswamp Shopping Centre in Joondana.

Thanks

Edited by MeLSki
Kurt (invasion) I can't PM for what ever reason. Just so you know the meet poitn is actually specified in the initial post if you read it it clearly states Dogswamp Shopping Centre in Joondana.

Thanks

SORRY, i did read post but i didnt know that Joondana was North of the river.

Edited by invasion

That's ok mate :P I just couldn't reply to your PM. I've tried to tell the mods but haven't had much luck in getting help with the issue so posted on here hoping you would read it so that's lucky :P wannerro rd is the best way to Joondana if that helps

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...