Jump to content
SAU Community

Recommended Posts

Ok my car is back on the market, I am looking to have it taken by the end of the month.

I suspect that the big end bearing(s) have been spun so it make a knocking noise. It is in its early stages of damage as it occurred not far from home, car is driveable.

I am asking for around 9.5 or BEST offer, as I need this taken by the end of the month, urgently. My reason for selling is genuine as time and $$$ does not permit me to continue with it (uni).

It has been a good vehicle up until this point and I really wish I could devote more resources into it.

What this car has (which has been the same since I purchased it):

- White 1989 October make, unverified 170,000km on the clock (35,000km driven by me);

- Stock engine, standard boost;

- Genuine HKS air filters;

- Less than 10,000km old 5-puck extra heavy duty clutch;

- Kakimoto full exhaust system from dump pipes;

- Aftermarket light weight R32 GTR rear spoiler;

- Recaro Driver seat (hole developed in kidney support);

- Speedline 17 x 9 white light weight rims, wrapped in 245/45/R17;

- Lowered springs on stock shocks.

It does need some painting to the bonnet and front bumper, which would be less than $500 to do.

Location is in Brisbane Southside. I will get pics as soon as I get new rego plates.

Please contact me via SAU or mobile and I will be happy to answer any questions! Cheers.

AB

0437 638 842

Link to comment
https://www.sau.com.au/forums/topic/255825-r32-gt-r-for-sale-asking-~95k-obo/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...