Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Martin by any chance were those two smoking hot cops in the area of Albion/clayfield? cause if so its true, they are actual cops. I have seen them before. Many an early morning RBT setup in that area, its one of our test drive runs (rougher roads in the backstreets there, good for testing for suspension noises)

Spot on: Clayfield. I think its Melton Rd, near the corner of Junction rd

the big operation? or a job?

Yer there is a couple hotties working around that area, pretty sure they are from hendra. Also some hot ones working for fortitude valley station

Yer there is a couple hotties working around that area, pretty sure they are from hendra. Also some hot ones working for fortitude valley station

When I got pulled over by an RX8 in Ascot a few months back, the chick that spoke to me had tigs that put Terri to shame!

Edited by Isola

post-46752-1257778407_thumb.jpg

Watched this on SBS. Very weird zombie movie with aliens in it. Weird but kinda cool. The sheila in it has four pump action shotguns mounted together.

worth watching?

what country?

I <3 Zombies

It was a good watch actually. Especially the way they brought in the aliens. I think it was a oz movie.

I'd give it 3 "brrrraaaiiiinnnnssss" out of 5

Its almost as good as that NZ zombie filum

post-46752-1257782052_thumb.jpg

That i'd give 4 squidgy innards out of five.

But nothing is as good as Shaun of the dead..

Farkn lol love that movie.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...