Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Only 4 weeks in to full time work... Already saying thank fu*k its friday.

Sorry Scott was heading there last night but got side tracked by KFC on the way :/

Where'd you get a job mate? Also, does this mean 30/25 conversion now?

Got an apprenticeship as a general engineer (fitter and turner) at mendham engineering.

They do have one of the most complete engine reconditioning facility's in QLD, so it would be very easy to do a 25/30.

But that would have to be in a different car. Na 33 might be sold in the next few weeks.

She goes alright. Gets the job done :)

Even if she is a German 31 :P

put a GPS speedo in the little ladies beetle today.....that was fun, but the end result is pretty (not that ive tested it yet).

and check your Messages, there is a VW related one in there for ya...has been for a while now :whistling:

post-62717-0-35550400-1337430421_thumb.jpg

post-62717-0-74148400-1337430443_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I'll get one of these also just for giggles
    • I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
×
×
  • Create New...