Jump to content
SAU Community

xr6 ute on autospeed

Driver

By Driver,
in General Automotive Discussion

 Share

Recommended Posts

MJ Mentor

MJ

Posted
Posted

That figure doesnt suprise me!, They really get up and go!

i raced a xr6t ute on sat night and it wasnt stock, he had mods similar to what you listed and he absolutely cained me hehe. They have the best of both worlds...a high capacity engine and turbo!

They really have a lot of potential it will be interesting to see what their limits are. They just need to lose a bit of weight

My uncle has a stock xr6t and i raced him one day, and he gave me a good run but i just had the edge on him due to my mods

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Julsmadrid
      RB25 Drama's

      By Julsmadrid · Posted

      Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • oxisau
      Jacks that fit under GTR lips that can reach the subframe?

      By oxisau · Posted

      I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • nash47
      Cas issue

      By nash47 · Posted

      No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • shubby0901
      Living With An R33 Gtst

      By shubby0901 · Posted

      Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
    • GTSBoy
      R34 - Switching cluster from non turbo auto --> turbo manual after diff change

      By GTSBoy · Posted

      I guess. The diff and the speedo are gearbox agnostic.
×
×
  • Create New...