Jump to content
SAU Community

R32 Rb25det With Lots Of Goodies.sa

driftn32

By driftn32,
in For Sale (Private Whole cars only)

 Share

Recommended Posts

driftn32 Proficient

driftn32

Posted
Posted

Description:

Raws car

1992 R32 Gts-t

Auction grade 3.5 car

100,000 on the 25 package

motor was rebuilt with new rings and bearings before fitting 20,000km ago

VG30 op6 Turbo (larger rear housing same as r34 gt-t)

New Arp headstuds

New timing belt

pod filter

Tomei 256 Intake cam

New Tomei 1.2mm metal headgasket

New front mount intercooler

full exhaust turbo to tip

full type M body kit rear pods etc

New extreme heavy duty clutch

New D1 strengthend shifter (same through just more postive feel)

Non Hicas S13 rear craddle

Alloy craddle bushes

coilovers

New Section rear camber arms

Ikea Formula Traction rods

New Kts tie rod ends

New Ikea Formula tie rods extra lock!

New Kenwood head deck

New Alloy Steering bush

New Nolthane Steering rack bushes

HID Cats Eye headlights

Gtr fuel pump

new clutch master cylinder

New front Brake pads

all new fuilds engine oil, brake fuild, clutch fuild, gearbox oil, diff oil all changed 2,500km ago or less

Alarm , keyless entry

custom tailshaft

custom gearbox mount

rb25gearbox

Pioneer 6inch speakers front and rear

Front slotted rotors

solid engine mounts

Jjr engine daMPNER

Front strut brace

Battery mounted in rear

New battery

Greddy stytle plenium

Nisno fuel pressure reg

Turbo smart fuel pressure gauge

Autronic smc computer

avs rims 16inch rims

$11,000ono. SA Strathalbyn 0431 540 141

Link to comment
https://www.sau.com.au/forums/topic/289963-r32-rb25det-with-lots-of-goodiessa/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...