Jump to content
SAU Community

Recommended Posts

Hi All,

Removed this due to going with a bigger turbo.

It's a T04Z copy turbo. I believe it was purchased from Rotormaster.

Has a genuine Garrett split pulse rear housing, 1.00 rear and Vband clamp.

Very little shaft play, but it is a little smokey at idle so needs a seal kit put through it. Still spools and boosts very well.

After $250.

Pickup available from either Cheltenham or Reservoir or I can post at the buyer's expense.

Thanks,

Justin.

251020091018.jpg

251020091017.jpg

251020091016.jpg

251020091019.jpg

I should point out, the Garrett rear housing is brand new, and has not been used.

Reason it has a Garrett rear is because I bought a brand new Garrett turbo. Turns out the rear housing dimensions were identical on this and the Garrett, so rather than stuff around with the dump pipe, I just kept the rear housing off this turbo on the Garrett.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I'll get one of these also just for giggles
    • I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
×
×
  • Create New...