Jump to content
SAU Community

Recommended Posts

SELLING A MANUAL GEARBOX R32 GTR BEEN RECENTLY PULLED OFF. SORRY I DONT HV ANY PICTURES OF IT BUT IT COMES TOGETHER WITH THE GEAR STICK WITHOUT THE KNOB. SELLING ONLY THE GEARBOX IF U WANT THE CLUTHCH PLATE ITS SEPARATE. ITS AN UPGRADED CLUTCH PLATE NOT SURE OF WHAT BRAND. BUT WILLING TO LET IT GO FOR $500. THE PRICE FOR THE GEARBOX WOULD BE $2000 FIRM. CALL ME IF U HV ANY INQUIRIES. WILL NOT POST ONLY PICK UP. CAR HAS DONE ABOUT 130000 KMS REZA 0432415424.

HAVE HEAPS OTHER PARTS AS WELL, INCLUDING DRIVE SHAFTS, CROSS MEMBER, STARTER MOTOR, FUEL PUMP, FUEL TANK, STOCK SPOILER, BOOT, LEFT FENDER, BOTH DOORS, WINDOW MOTORS, AFTER MARTKET EXHAUST NOT SURE WHAT BRAND, BRAKES COMPONENTS, CLUTCH MASTER CYLINDER, BRAKE MASTER CYLINDER, BUCKET SEATS MINT CONDITION, STEERING WRECK WITHOUT RACK ENDS, 19 INCH RIMS WITH TYRES HAS A STRATCHES FROM THE ACCIDENT, TAIL SHAFT, DIFF, TIEN REAR SHOCKERS WITH SPRINGS.

IF U WANT FAST RESPONSE I WOULD ADVISE YOU TO CALL ME AS I DONT OFTEN GET THE CHANCE TO GO ONLINE.

FOR ALL THE ITEMS ABOVE, JUST MAKE AN OFFER. ANY OFFERS MIGHT BE CONSIDERED. JUST WANNA GET RID OF THESE ITEMS. BUT PLEASE MAKE REALISTIC OFFERS

post-36577-1258607669_thumb.jpg

post-36577-1258607724_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/296914-heap-of-r32-gtr-parts-for-sale-melb/
Share on other sites

Price on front drive shaft??? or just the rhs inner cv joint???...delivered sydney......

front drive shafts 120 each...delivering im really not sure how do i go about doing that..if u can suggest anything im willing to send the pair at buyers cost

Hey mate i'm 3 sensors.

The first one is the out side temp sensor ( located near the aircon fan )

The second is inside temp sensor located in the center console near the cig lighter.

The third is the sunload sensor which is located in the dash passenger side top near the windscreen.

How much for these sensors.

Oh and can you confirm if your aircon was working

ahha nothing..i just dont know what they go for...i assumed it was much more as the r33 gtst was around 1k

r33 gtst ones can handle more power. harder to come by as more everyone wants them... going rate for r32 gtr is around 5-600$

  • 2 weeks later...

Hey mate

im after the rubber spacer that goes under the gtr wing on the outside drivers side.

Not the one that gets bolted down but the outside one.

Can pick up.

If you have it how much do you want?

Need it bad

Cheers mate

  • 7 months later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Was going to say the car pulls up nicely everywhere, especially going into that last long right hander before the main straight. Looks like a lot of fun.
    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
×
×
  • Create New...