Jump to content
SAU Community

Sa: New Siemens Deka #3145 750cc Injectors - $450

SLAPS
 Share

Recommended Posts

SLAPS Rising Star

SLAPS

Posted
Posted (edited)

Bran new Genuine Siemens Deka #3145 750cc Injectors.

Never used as I ended up dropping a set of 1200cc injectors in the RB30DET (R32 RB25DE Head).

Part Number: 3145 - 72lb low resistance.

Flow Rate: 750cc/min (72lbs/hr) @ 43.5 PSI - 909cc/min (86.6lb/hr) @ 58PSI

Coil Resistance: 2.2 Ohms / Low Impedance / Low-Z (Peak-Hold ECM drivers or injector driver/converter needed)

Physical Dimensions: EV1 Body Type

Connector: Bosch EV1

O-Rings: Included

Atomisation: Excellent

100% bolt up, no fiddling with aftermarket fuel rails or injector clips.

Direct fit for RB26DET, RB20DET or R32 RBB25DE. Unsure if they fit RB30ET.

Located in Adelaide, South Australia

$450 + Postage (pickup available)

post-58245-1259118676_thumb.jpg

post-58245-1259118680_thumb.jpg

Edited by SLAPS

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Haggerty
      RB25DE NEO with Haltech ECU

      By Haggerty · Posted

      Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • brillo
      Leak from Tokico BM50 Brake Master Cylinder

      By brillo · Posted

      Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • MBS206
      Cas issue

      By MBS206 · Posted

      It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • nash47
      Cas issue

      By nash47 · Posted

      Yes sir am asking is there possible way from aem tuner from wiring pins 
    • MBS206
      Cas issue

      By MBS206 · Posted

      Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...