Jump to content
SAU Community

Recommended Posts

Hi i have for sale a Genuine Holset H1E its brand new never been fitted i was going to use this on my car how ever i have decided to go a different route. Its a T4 flange think. Its has an 8 blade compressor wheel. There is a picture next to a garrett t3 off a skyline. I can post australia wide at buyers cost, but unsure on postage cost due to weight.

post-40351-1259132211_thumb.jpg

post-40351-1259132226_thumb.jpg

post-40351-1259132242_thumb.jpg

post-40351-1259132256_thumb.jpg

post-40351-1259132266_thumb.jpg

post-40351-1259132275_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/297720-holset-turbo-h1e-brand-new-750/
Share on other sites

  • 1 month later...
  • 2 weeks later...
I.D of turbine hosing outlet is 8cm

O.D of turbine housing outlet is 10cm

Sorry not what i was after. Need the A/R. On holsets, its usually in cm2 Should be marked on the housing.

Hey mate not too sure hey you would need to get a t3 to t4 adapter and make an exhaust to fit onto it other then that not too sure.

do u know what this will fit easly?
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...