Jump to content
SAU Community

Recommended Posts

the idicator is all orange not a clear,just to let you know.yeah widow switch works fine.

ok. Didnt end up needing the indicator, but still interested in the window switch.

Is $40 + postage ok?

is the link ecu just a remapped unit , or is is live tuning enabled?

i think it live tuneing do u want more photos link is printed on the actual board and all the chips

Is the diff complete in a housing? whats the diff ratio too? thanks

nah theres a pic on first page, it the centre half shafts and drive shafts,cost me $750 and havent even used it,it done about 13,000km from new my mate bought it new,never been to track

hey chris , how you doing man , just wandering if you still have that uras cefiro front bar lying around ?

let me know asap man

thanks for your time

cheers anf

hey mate

Have you got the pc cable, map sensor, anti static strap, and all the gear you get when you buy a link ecu new?

  • 2 weeks later...
nismo 2way lsd centre 6 bolt suit s14,ect$500

6bolt drive shafts$100

25mm wheelworx 4 to 5 stud spacers $450 SOLD

r32 diff,cradle,shafts,all arms,$300

slip on 4 stud 5mm spacers $20SSOLD

link r20det ecu direct plug in $400

rb20det injectors $50SOLD

r32 left hand indicator $30SOLD

r32 left hand head light $50SOLD

r32 rb20det ecu $100SOLD

rb25 crank angle sensor $80

walker 2inch cat brand new $50

walker 2inch muffler brand new $50

RB25 cam covers$40

rear cannon 2inch inlet 4inch outlet brand new $50

r32 window switch ass$50

r32 rear hubs,rotors,calipers,ect $250

uras cefiro front bar $150

rb25 top and bottom half of intake manifold $50

rb20 cam cover $15

r32 left hand door black,with window$150

cefiro front seats $50

r31 s3 head lights$40SOLD

31 s3 bonnet silver$80SOLD

31 sedan doors silver,with widows $30each SOLD

31 s3 boot $50SOLD

s3 taillights $40SOLD

s3 tinted back $60SOLD

s3 front bar$40SOLD

brand new 2jz water pump$100SOLD

SA STRATHALBYN 0431 540 141

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...