Jump to content
SAU Community

Recommended Posts

Hey all,

Sold my old project and clearing out the shed.

1) Series 2 RB30 engine, has turbo pistons but is A6 block, engine is now removed from car had a rattle at 2500 rpm neutral throttle, manifolds and turbo gear have been sold $150 ono

post-72691-1278747325_thumb.jpg

2) Mx7 5 speed conversion, has everything to bolt up and go except centre console bits, the pedal kit doesn't have the correct clutch master cylinder pin and only has standard starter ground to clear flywheel, asking $1300 ono.

post-72691-1278747605_thumb.jpg

3) Suspension components, mostly standard springs and some lowered and shocks to suit $10 ea

post-72691-1278747136_thumb.jpg

4) Series 2 berlina interior, have seats/doortrims/rooflining/carpets and some misc stuff. $5-$40 per part or make an offer for the lot.

post-72691-1278748653_thumb.jpgpost-72691-1278747995_thumb.jpg

5) Vl calais flip up front end, silver in colour great condition everything works includes corner pieces $650 ono

post-72691-1278748332_thumb.jpg

6) Monaro 18x8 CV8 rims set of 4 in good condition $500

post-72691-1278749140_thumb.jpg

Got more random stuff feel free to ask and i'll see if i have it, pm or email [email protected].

5 speed conversion SOLD.

Better pics/more stuff

Monaro rims $450.

post-72691-1279342859_thumb.jpg

Vl berlina rear seat in grey $120

post-72691-1279342939_thumb.jpg

Vl berlina front seats in grey $130

post-72691-1279343007_thumb.jpg

Vl 3 core radiator excellent condition will throw in fan shroud and hoses for free $40

post-72691-1279343190_thumb.jpg

15x6 chaser rims on 225/60/15 tyres minimal tread $20 each also 205/65/15 tyres 50-80% tread + 2x 225/40/18 tyres fair bit of shock wear $20-30 each.

post-72691-1279343598_thumb.jpgpost-72691-1279343772_thumb.jpg

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...