Jump to content
SAU Community

17x9 +10 Deep Dish Jap Meshies

spunkrat
 Share

Recommended Posts

spunkrat Contributor

spunkrat

Posted
Posted (edited)

Got my last pair of wide, low offset wheels up for sale. Meshies that I got from Japan. 17 x 9 +10, stepped dish. Good condition. No tyres.

Wheels are located in Brisbane at my brothers house. PM me here and I'll sort out pick up.

$800 or nearest offer.

Sickrims.jpg

20080501_3003_1024x682.jpg

On the back of my brothers R32 4 door.

post-882-1278850923.jpg

post-882-1278850896.jpg

Cheers,

Bren

Edited by spunkrat
Link to comment
https://www.sau.com.au/forums/topic/341616-17x9-10-deep-dish-jap-meshies/
Share on other sites
chris321 Newbie

chris321

Posted
Posted

Im in bris and very interested mate, would you take $700. . . ? I could probly pick them up this arvo or tomorow. . .

Give me a text or call on 0415 601 759 to let me know what you think.

Regards, chris.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • MBS206
      Cas issue

      By MBS206 · Posted

      Was that with the cas upside or correct way up?
    • nash47
      Cas issue

      By nash47 · Posted

      Did and sync timing with light 
    • MBS206
      Cas issue

      By MBS206 · Posted

      Have you done the Ignition Sync Wizard in the AEM software?
    • MBS206
      R32 GTS (RB20DE) Injectors Replacement

      By MBS206 · Posted

      Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • MBS206
      RB25DE NEO with Haltech ECU

      By MBS206 · Posted

      You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
×
×
  • Create New...