Jump to content
SAU Community

Recommended Posts

Rare japanese Rays championato ss7 's

18inch

front 8.5 +33

rear 9.5 +38

114.3 pcd

245's all around, good tread .rear wheels have wider face then front

matt black in finish

looking for $1000, or possible trade with stock s15 rim + $700 cash

pm me for more info, after quick sale/trade this week

located sydney , silverwater 2128

post-32277-0-52488900-1298798165_thumb.jpg

post-32277-0-83834700-1298798229_thumb.jpg

post-32277-0-74623300-1298798320_thumb.jpg

post-32277-0-91641200-1298798428_thumb.jpg

Edited by sky017
Link to comment
https://www.sau.com.au/forums/topic/355450-rays-championato-ss7-s-18inch/
Share on other sites

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...