Jump to content
SAU Community

Recommended Posts

I didn't mean return flow at all, I have a BLITZ cooler on mine and it doesn't interfere with anything, I've even put on an NA airbox (unfortunately I didn't get one when I bought the car) to pass an EPA and he didn't have a problem with it.

You might be entirely right I haven't really looked into my cooler model and all that. Still shouldnt effect whether or not you have aftermarket pipes or not though because any intercooler that isn't return flow shouldn't have any pipes that interfere in front of the turbo, unless the kit comes with a compressor housing pipe that doesn't make use of the factory hole. I would think he has an NA box though as when I went for my EPA the NA Air Box fouled on the second factory hole (closer to passenger side guard).

my genuine hybrid cooler didn't foul with the airbox, but the pipe from the cooler to the plenum that ran along the top of the radiator stopped the airbox snorkel from fitting back on, and it wasn't just a minor clearance issue.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...