Jump to content
SAU Community

Recommended Posts

*disclaimer*

naturally these are done in a controlled environment and not at my local rsl carpark at 3 in the morning[/quote:4fbd129fe0]

He he he... That's funny....

When at my mates PRIVATE skidpan, I gennerally just start in the middle (away from everything), full right hand lock, rev up to about 4000rpm and dump clutch... A quick snap into second and there you go. You'll need to correct as you go, but that should give you a good start. Try to keep the revs to around 5-6000rpm by feathering the go peddal.

If it's wet or a bit damp, just start off in second and dump it at 4-5000rpm.

J

  • 2 weeks later...

found a very very suitable car park to learn the ways of the donut. it's a 50x50m (roughly) carpark with brand new bitumen that is smooth as. no bumps, no spead humps, no cameras, no ppl, no roads, no houses. just brand spanking new bitumen crying out to be used.

it's located just south of the city, about 10 min from cbd. it's not a residential zone and there isn't any real roads so no cars drive past.

if you are interested in joining me late one night, drop me a pm.

i'll be heading out there prolly after tomorrow nights cruise.:burnout:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...