Jump to content
SAU Community

Switch Underneth Dash On Drvers Side Down By The Throtle 0N Rs4 Stagea 1996?


Recommended Posts

does any1 no wat this switch does on my rs4 stagea???? its underneth the dash on drivers side by the throtle on the side cover????????

it is the emergency driver ejection button

pls press it.

That's the factory reset button, personally I would never have pushed it.

but it didnt do anything and my car is fine it hasent done anythig to it

at all.

Are you sure?

Must not be modified then... standard tune ect

its just had a s2 rb25det stagea engine put in it cos the old s1 crapd out.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • A few random issues have popped up since my last update. My WMI pressure sensor failed within about 10 minutes of it seeing liquid. It was a 20$ China special, so I'm not surprised. My name brand replacement should arrive today.  My power steering assist also decided to crap out last weekend. The usual, works for about 60 seconds after starting the car then I lose it. I dusted off my old copy of NDS and connected to the HICAS ECU. Code 4 for assist solenoid.... I tested the solenoid and it's fine.  I knew the day where my HICAS ecu would crap out would come, and I welcome it. It was the last HICAS part on the car that is now in the bin. I've ordered an SSR and I will control the power steering solenoid with my Haltech ecu. It will be nice to have proper speed referenced assist again after all these years.   
    • Haha I just finished the last season of TPB: Jail last month. I'm happy they're still pumping out episodes. 
    • We want to see pictures of the carnage! 
    • The picture of the underside of that PCB shows either old flux that wasn't cleaned properly or some other contaminant (I.E Water). I would flush it with ISO and try again. 
    • @silviaz Are you skim coating the entire panel (covering the entire panel with filler) before your hitting it with the long block? Or are you selectively applying filler to the repair, trying to fill the low points?  Please don't do that.  Almost certainly. Are you checking the panel for flatness as you go? Or is it more a case of, sand til all the guide coat is gone then check? 
×
×
  • Create New...