Jump to content
SAU Community

Recommended Posts

Hi,

Just got a 1990 Skyline R32 GTR and it's completely stock except for Exhaust.

Since you guys know alot about these cars I need some help.

I'm wanting to beef up this car to make it a 11 second monster.

What could I do to accomplish this.. and how much (AWHP) would I need to make this happen..

Apperciate your reply's

Joe

Link to comment
https://www.sau.com.au/forums/topic/39881-usa-r32-skyline-upgrades/
Share on other sites

Hi,

in australia there is a 11.56 second R32 pretty much stock... most R32 GTR's can enter 11 seconds with pretty much no modifications if the engine is fresh.

well dont GTR's do 14 seconds in the usa ?

Anyway

modz you need to bust 11 seconds. still using stock turbines.

Apexi PFC

HKS Adjustable cam gears

Dumps and full exhaust system 3" adn 4" tip would be good.

275/35 tyres all around your car with some good pair of light wheels." try importing some NT555R's from japan. ( Nitto )

1bar boost

hks evc2 boost controller

this is most likly a really low 12 and high 11's since you will have nitto's.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • bumping this post as im still having dramas, my fuel pick up is sitting on the bottom of the tank, my pump gets a constant 13 volts through a relay, my fuel pressure holds consistently without fluttering or dropping, yet as soon as im near half a tank of fuel my car starts fuel starving and leaning out, it cant be due to g force as it never pulls hard enough before it starts breaking up, any help would be much appreciated 
    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
×
×
  • Create New...