Jump to content
SAU Community

R33 4 Door - 235Rwkw - Rego Till 2013 May - $8500 Ono !

55psi

By 55psi,
in For Sale (Private Whole cars only)

 Share

Recommended Posts

55psi Explorer

55psi

Posted
Posted (edited)

FOR SALE 1994 R33 4 door Skyline GTST

$8500 ONO

235rwkW

Rego expiry - 2013 May

Reason for selling is that I need to money to go to Japan towards the end of the year. This has been an awesome car, has been an awesome daily (now have a work car), and I have taken it to the track a couple of times with no issues at all, super reliable.

Have recently changed the oil with Nulon Fast Flow 10w-40, changed gearbox oil to Redline MT-90, and changed fuel filter.

ENGINE MODS:

· High flow RB25 turbo by GCG

· Apexi PowerFC

· Z32 AFM

· S15 injectors (bigger than standard RB25)

· Tomei Fuel Pump (Output 540PS 248 L/h - Standard 136 L\h)

· ‘Yellow Jacket’ coilpacks

· Apexi high flow panel filter (standard airbox, COP FRIENDLY!)

· Turbotech boost controller

· FMIC

· Kakimoto 3” exhaust from turbo with Catco High flow cat

DRIVELINE & SUSPENSION MODS:

· Shimmed diff, nice and tight

· JIC adjustable coilovers all round

· Rear Whiteline GTR swaybar (the biggest and best!)

· Rear adjustable camber arms

· Adjustable castor rods

· Steering lock spacers

· Alloy sub-frame lock rings

· AVS Model 5 rims. Rear 17x9 (+36) Front 17x8 (+34)

· Front adjustable 30mm spacers

· Potenza RE01 tyres all round, approx. 50% tread left.

Bad points:

· The only bad points on the car are only cosmetic. Front bar paint has seen better days (see pics). There are a couple of areas where there is lack of clear coat, and a couple of dings.

Other than that, the car runs sweet, turns heads, sounds good, and drifts nicely too if that’s what you were intending to do. Have never had any cop attention, and if you did, you should be safe as its not dropped on its guts and no pod etc.

The car will not come with the Bride seat (in pics) and will come with a different deep dish steering wheel.

CONTACT:

PM me, or call me on 0421737070.

Im also located in Newcastle NSW

post-84332-0-46677000-1345981798_thumb.jpg

post-84332-0-63172500-1345981644_thumb.jpg

post-84332-0-15201500-1345981588_thumb.jpg

post-84332-0-36188600-1345981740_thumb.jpg

img0057ff.jpg

Uploaded with ImageShack.us

Edited by 55psi
  • 2 weeks later...
  • 3 weeks later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      New kid on the block

      By GTSBoy · Posted

      The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Duncan
      New kid on the block

      By Duncan · Posted

      Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • iain_ST44GA
      M35 VQ25DET starter motor

      By iain_ST44GA · Posted

      Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • Murray_Calavera
      R33 GTR running -9 with no tune

      By Murray_Calavera · Posted

      I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...