Jump to content
SAU Community

Recommended Posts

http://www.sydneydragway.com.au/?m=events&a=event_page&id=130

If the weather is good Im going.

Post up if your going, we will get ourselves into a group and race for donuts.

Even if your not racing come along and say hi, if your a NSW SAU member I can sign you in as pit crew and you can chill on the line.

Ill be there in my boat from around 5:30pm.

Its a good time to see how your car will go for the SAU NATS airport run.

Prior Preperation Prevents Piss Poor Performance.

DO IT

Link to comment
https://www.sau.com.au/forums/topic/412333-wsid-31-oct-2012/
Share on other sites



  • Similar Content

  • Latest Posts

    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
×
×
  • Create New...