Jump to content
SAU Community

Recommended Posts

Genunine garrett gt3082r (aka 3040). T3 flange, 4bolt 3inch gt exhaust flange 0.63. 4"inlet 2" outlet 0.7 compressor

This is the monster 35r compressor wheel on a smaller quick spooling 30 series housing.

Dual ball bearing, water & oil cooled. Only ever run on full synthetic oil. ZERO shaft play, 10xxx ks old. Rated at 600Hp.

$1500.00 ono

post-27103-0-29739100-1358929733_thumb.jpg

post-27103-0-30064600-1358929750_thumb.jpg

post-27103-0-11219300-1358929766_thumb.jpg

post-27103-0-30437200-1358929787_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/418411-garrett-gt3082r-aka-3040/
Share on other sites

Hi mate, is it internal or external gate? And would this bolt up to a standard rb25 NEO manifold?

Tonksy it is an external wastegate turbo as you can see by the rear housing, it would need a spacer plate, lines and new dump as well as a wastegate off the Ex manifold, answer is YES it can be done.

No it's not a gt3540. It a gt3082r aka gt3040. It's got the gt30r exhaust wheel with a gt3540 compressor wheel. Good for 390rwkw on juice. Would be ok on a internally stock rb25 but depending how far you push it, the tune and fuel will depend how long your motor will last. Top turbo. R31nismoid would vouch for this I'm sure!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...