Jump to content
SAU Community

Bne - 4Xtoyo Proxes 235/45/17

hardsteppa

By hardsteppa,
in Classifieds

 Share

Recommended Posts

hardsteppa Grand Master

hardsteppa

Posted
Posted

Located on Brisbane northside - 4 xToyo Proxes 234/45/17, approx 40-50% tread left. 2 tyres have alot of inside camber wear right on edge, but rest of tyre is fine, and other 2 have mild inner camber wear but still good. The worn 2 would not meet RWC but still plenty of rubber left for track work. Pickup or delivery available, located in Northgate here. Closeup photo shows the worst-worn tyre, rest are better. $100 the lot

post-78602-0-53168500-1377416360_thumb.j post-78602-0-36484200-1377416382_thumb.j post-78602-0-15031500-1377416481_thumb.j post-78602-0-67583600-1377416492_thumb.j

Link to comment
https://www.sau.com.au/forums/topic/430793-bne-4xtoyo-proxes-2354517/
Share on other sites
 Share
Go to topic listing


  • Latest Posts

    • TurboTapin
      remote oil cooler hose size, 8,10 or an12?

      By TurboTapin · Posted

      Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hendasto
      Lets play a game - What is causing my oil consumption?

      By Hendasto · Posted

      Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • Hendasto
      Are RBs worth building reliability wise

      By Hendasto · Posted

      At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...