Jump to content
SAU Community

Recommended Posts

HKS EIDS

HKS idle Stabilizer. Helps solve the stalling problem caused by most ATMO BOVs.

Comes with Computer, Loom and Instructions.

PriceSOLD (UAS have one for $280)

Buyer buys postage from SA. Prefer Direct Deposit, COD maybe.

in excellent cond.

Thanks, Dean

Link to comment
https://www.sau.com.au/forums/topic/44218-fs-unichip-ebc-and-hks-eids/
Share on other sites

calemb : If uve ever installed a car stereo, then u can easily install this. U need to tap into only 8 wires. Took me 10 mins to install.

Yes it works on autos

Yes it works with other EBCs however it works as good if not better then the brand name ones. Buy this, and sell the brand name one if u r happy with it, and u saved urself a shitload. :)

Pics Finally,

Sorry about the crapness of them, my camera isnt workin so i had to use my el crappo one.

Pics are Unichip and Boost controller Modules

Wiring loom pic of boost controller and Unichip (Still attached to my car)

Thanks

Dean

read this link... it tells you why you should install a unichip intto your car.

http://www.airpowersystems.com.au/unichip/unichip.htm

The Unichip not only enhances power and torque across all throttle positions throughout the entire rev range, but significantly enhances throttle response, driveability, fuel economy and outright acceleration.

gtr_rb26.gif

James.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
    • Haha, that's so true. Minimal plans quickly turn into a full transformation, especially when you see what others are doing
×
×
  • Create New...