Jump to content
SAU Community

[Nsw] Bosch 023 Fuel Pump - Sard Fuel Reg - Ebc Red Pads

geetea-are
 Share

Recommended Posts

geetea-are Community Regular

geetea-are

Posted
Posted (edited)

Bosch 023 in R32 GT-R Cradle

This is fitted to a r32 gtr cradle, so it a direct drop in for any one with one. The 023 is said to be the same as a Nismo pump so will produce very similar flow rates.

- $80

Sard Fuel Pressure Regulator

This is a genuine Sard Fuel Pressure reg, it has had very little use.

-$60

EBC Reds (new)

These fit on the rear of a r32 gt-r im not sure what else they are compatible with. (If you want a photo of them in their packet pm me)

- $45

post-98548-0-54130900-1400583182_thumb.jpgpost-98548-0-27847800-1400583184_thumb.jpgpost-98548-0-94816000-1400583185_thumb.jpg

Edited by geetea-are
geetea-are Community Regular

geetea-are

Posted
  • Author
Posted

Hesh, your best option is posting the question on the forum, some one would have the answer. I'm not going to say yes for you to buy it then it not fit.

Cheers Elliot

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      I am well aware as I did rant at him to buy a MX5, buy the 2.5 before he DIY'ed it, etc as well as do things to the holden. He will obtain a ND. It's the best of both worlds. They look great in person, definitely the best looking one. Just a matter of time now.
    • r32-25t
      NC MX5

      By r32-25t · Posted

      Remember this is the same person who said he’d never own an nc 
    • zique
      Ceramic turbine damage to engine - what did yours do?

      By zique · Posted

      ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
×
×
  • Create New...