Jump to content
SAU Community

Recommended Posts

Looking to trade for another tastefully modded Nissan,

Why? I don’t really know why I just feel like a change.

Specs,

1993 300ZX Twin Turbo, 2 Seater Targa Top, 132,000 km's serviced every 5,000

Full 100,000km service preformed at 102,000 km's

5spd MT with short throw shifter

Unknown brand Heavy duty possibly brass button clutch

Rush 02 Race pod

Radiator air guide

3" front pipe back twin exhaust, not dump pipe back, with Magnaflow DTM tips

Custom Made FMIC and hard pipe kit (polished)

HKS Super Blow Off Valve Kit, mounted on hard pipes. (old skool HKS bov's)

HKS turbo timer

TOMIE 320Km/h Speedo

Greddy Profec B Electronic Boost controller

Greddy pillar mount boost gauge

Greddy Shifter knob

Greddy Speed cut defender

Aftermarket Steering wheel with nismo horn

Cusco rear strut brace

New suspension bushes

Adjustable Camber rods on the front

Dropped on its guts, also have original ride height springs

Ewing 17" Dish rims (Jap) 255's rear and 235 fronts

Full Bomex Body kit, Front bar/Side skirts/Lower rear bar/Wing/Center nose panel

Interior is in great condition, as with the body but as usual front bar needs a re spray from various stone chips.

Just had it dynode yesterday made 304.3 RWHP at .85-.9 bar boost hasn’t ever been tuned, and the AF was really rich where it was making the power as Nissans do so a tune should see a much higher figure.

300dyno.jpg

Pics of the car, *note some where taken before certain things where done etc... *

MyzedsFMIC.jpg

phatlowerage2.jpg

300zinside.jpg

300zspeedo.jpg

dusk-18-2.jpg

300Zee-Grass1.jpg

TheZed.jpg

To contact e-mail me at [email protected]

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...