Jump to content
SAU Community

Recommended Posts

Im a bit of a newb to the skylines i only got mine about 3 weeks ago. Anyway on friday while driving i noticed my car was loosing power, i would notice it would lose power but then i could put my foot down again and it was fine. Later that day i was driving along when my engine cut out and wouldn't start again. I disconnected one of the fuel lines and turned the ignition to pos #3 to prime the fuel pump but no fuel came out the line, cranked engine over still no fuel.

Got her towed home and i have just checked the fuel pump wiring. On the pump are 5 wires going though 2 clips i put a multi meter on them and turned ignition to pos #3

Grey Clip

Black Wire - Earthed (confirmed)

Green? Wire - 12v

Gray w/red strip - 8v

Brown Clip

Two wires can't remember the colour but both showed zero volts.

Can anyone confirm for me what each of these wires do? And with confirmed power through the grey clip can i conclude that my fuel pump has died?

Cheers for any help guys

Link to comment
https://www.sau.com.au/forums/topic/59611-fuel-pump-dead/
Share on other sites

the grey clip sounds like your fuel guage sender unit.. with the grey w/red strip being the response wire which will vary with fuel lvl!

the brown clip sounds like your fuel pump wire... since the R33's use the ECU to vary the current on idle means that your pump is not gettion power from the ECU .. check that PIN 18 is properl;y connected by removeing the kick panel and unplugging then reinserting the plug ....

the fuel relay in the rear fuse panel may also be blown .. check those too and have them tested properly.. im no where near my line so i can check which one it is for you.. shouldn't be hard to diagnose this, and i doubt that it would be the pump causing this situation!

Hope this helps :cheers:

CT

Link to comment
https://www.sau.com.au/forums/topic/59611-fuel-pump-dead/#findComment-1137735
Share on other sites

Ok well i went through the boot and found the fuel pump relay. It looks ok but im going to buy another one today and chuck it in. Fingers crossed that that will fix it :D

I pulled the ECU harness off in the kick panel but i'll be buggered if i can match pins to the wiring diagram that sherlock_nzl posted :D

Link to comment
https://www.sau.com.au/forums/topic/59611-fuel-pump-dead/#findComment-1138746
Share on other sites

Chucked a new fuel relay in just to see if that was the problem but it didn't make a difference.

I was just going to get the relay tested but when i range up the parts place they said they have some which are classified as old stock so i could have one for $20

Bargain :D So even thou it wasn't the problem at least i have one spare now :D

Can anyone recommend anything else before i get it towed to a mechanic...

Link to comment
https://www.sau.com.au/forums/topic/59611-fuel-pump-dead/#findComment-1138879
Share on other sites

Ok update, im a idiot! Spoke to my mechanic friend who told me a fact i should have known. When turning the ignition on it only supplies power to the pump for approx 3 seconds. So by the time i got to the back of the car to check the multi meter the power was off.

I checked it again and there is power getting to the pump so its definatly a faulty pump :D Time for a new pump... *sigh*

Link to comment
https://www.sau.com.au/forums/topic/59611-fuel-pump-dead/#findComment-1138949
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...