Jump to content
SAU Community

Recommended Posts

I've got a pretty loud squeak coming from the front left of my r33 gtst. Anyone got any ideas as to what it could be, wheel bearing perhaps? It sounds like metal on metal alot like the sound the aluminium tray on my dads ute makes actually. It's louder when I'm going slow.

Any help would be awesome. Cheers

Link to comment
https://www.sau.com.au/forums/topic/61063-squeaking-front-end/
Share on other sites

i had a sqeeking noise on the front left of my 33 a while ago (got me so paranoid i thought it was from the middle of the car as well). Got it checked out and everything was fine, and the noise even went away just before i got it checked.

Then it came back and went away, my mechanic said it was the shock absorber and stated that the majority of shocks on the skylines are usually worn out if they are still factory items when they come out here.

So it could just be you shock like it was on mine.

Is it a constantly light squeel that is not too loud but just enough to annoy the crap out of you?

If so I've got one on my right wheel. :cheers:

I've had the wheel bearing done on that wheel quite some time ago, its not the wheel bearing. I'm thinking something to do with the brakes?!?

Wheel bearings tend to have more of a grind brup brup brup brup type sound.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
    • Yes then it will turn on but I want the car features to work  
    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
×
×
  • Create New...