Jump to content
SAU Community

can you heat wrap mild steel dump pipe?

Cefiro_PWA
 Share

Recommended Posts

RB30-POWER Mentor

RB30-POWER

Posted
Posted

I would say it would depend on the quality of the wrap itself.

There is alot of cheap and nasty heat wrap on the market at the moment, that I would be lucky to put near NA extractors, let alone a turbo dump pipe.

Buy some good quality wrap, which will cost a abit, and it may even have a heat rating on the packaging or manufacturer specs may provide the ratings.

Steve Grand Master

Steve

Posted
Posted

Apparently, because the heat cannot dissapate as quickly, the properties of the steel may change.

I didnt have any problems with my dump being wrapped (mild steel), after 12 months it was still perfect condition, visually. I didnt really have a choice, as the underbonnet temps were pretty crazy :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      Strange issue RB25DET wont start

      By Kinkstaah · Posted

      I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • Kinkstaah
      First time Skyline owner

      By Kinkstaah · Posted

      The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • Kinkstaah
      Chris' Toyota Mark ii JZX110

      By Kinkstaah · Posted

      I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • GTSBoy
      Chris' Toyota Mark ii JZX110

      By GTSBoy · Posted

      I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
    • GTSBoy
      Strange issue RB25DET wont start

      By GTSBoy · Posted

      Yeah, I would have said the same. It makes me suggest that there are other things wrong, such that the ECU is totally unhappy with the broken sensor. The only other thought here is that maybe it is shorted, which might cause a different issue to the typical "disconnected" sensor.
×
×
  • Create New...