Jump to content
SAU Community

Recommended Posts

Item: Nissan 180SX 1992

Location: Redcliffe QLD

Item Condition: GC

Price and Payment Conditions: $13 000ono.

Extra Info:

SR20DET conversion

93 XXXklms

Manual

Garret T25 Turbo

new clutch and gear box

Brand new Hybrid intercooler and piping

Body Kit

17" rims and good tyres

New True 28 Tinting

Security Alarm

Boost guage

Turbosmart Dual stage Boost controller and incabin switch

king springs

K&N Air filter

Blitz BOV

Intec Computer

Air Conditioner

Climate Control

Pioneer CD

6" speakers in the front and 7"x10" speakers in the rear

3" exhuast

new cannon exhaust

new steering wheel and Knob

Car Champagne Gold Metallic in Colour

Rego till October 2005

Safety Cert.

Contact Details: Marty on 0402 227 330

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...