Jump to content
SAU Community

Recommended Posts

sparcoseats.jpg

sparcoseat.jpg

Two Sparco Supersport, grey fabric. Microtilt adjustment, Immaculate condition, no stains, rips, tears. Reclinable with a quick-tilt forward mechanism, so ideal for use in 2 door cars. Sparco slider rails to match.

Only in my prelude for 4 months before I sold the car! Was going to buy a skyline (and put the seats into that), but things didn't go as planned.

These also have a little "FIA" sticker on the side so I believe have some kind of FIA approval for use in professional motorsports, can send pic of the sticker if needed.

Located in Melbourne, can ship interstate approx $100 depending on your location. Cost $2700, will sell for $2000 or best reasonable offer.

For those people seriously interested in the seats, email me only (don't reply in this forum) at [email protected]; as I won't check replies in the forum often but I check email regularly.

Link to comment
https://www.sau.com.au/forums/topic/8492-fs-pair-sparco-supersport-seats/
Share on other sites

  • 9 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...